Orient the ring adapters to the tube end as shown in the diagram below. With the ring flush to the tube
end, twist the ring so the leading point of the tube coil slides into the inner ring grooves. Twist enough
rotations for a solid connection and repeat for other tube end.
Insert the Unit Adapter of the Vent Tube assembly into the slots of each side of the air outlet and slide
down the Unit Adapter. The tube will slide in securely in place.
UNIT
ADAPTER
WINDOW SLIDER
ADAPTER
(CLOCKWISE ROTATION)
STEP TWO:
Installing the
Vent Hose
Assembly to the
Unit
5
1
2
1
3
2
A
B
Underside
View
C
B
A
Topside View
Based on the size of your window, adjust the size of the Window Slider.
If the width of the window is short use slider section “A” and cut to size, sections “A” and “B” for
mid-length or all three sections “A” and “B” and “C” for extra length if needed for vertical installations.
Assembly steps:
Start with slider section (A) and insert a T-screw
mount (1) through the underside hole (2) and
screw on locking knob (3) VERY LOOSELY.
Slide the assembled section (A) around the end
of section (B) with the T-screw sliding into the
center channel groove.
Repeat for section (C) if needed and adjust com-
pleted slider length to window measurement.
Tighten locking knobs to secure panel connection.
STEP THREE:
Preparing the
Adjustable
Window Slider
