MP5017-2002
Accu-Steam Gas Griddle
13
3.5 CLEARANCES
Level left to right
Level
front to
back
Griddle cooking surface
Fig 3.A
3.6 LEVELING
The appliance must be installed in a level
condition. An out-of-level condition may cause
uneven temperatures and in a severe out of level
condition damage to the appliance can occur.
Use a spirit level resting on the appliance cooking
surface to ensure it is level front-to-back and
left-to-right.
3.7 TABLE TOP
Install the (4) rubber foot tips provided with your
appliance onto the four foot adjusters of each of
the commercial appliance legs. This will keep the
griddle from sliding on the counter-top under
normal use. Once the rubber foot tips have been
installed, adjust the four foot adjusters up or
down as needed to level the griddle side to side
and front to back.
THE UNIT SHOULD NOT BE FLUSH MOUNTED
UNDER ANY CIRCUMSTANCES.
Location
Combustible
Construction
Non-Combustible
Construction
Back
2 Inches
0 inches
Right Side
1 Inch
0 inches
Left Side
1 inch
0 inches
Above
Flue
No combustible
materials above
flue
6 inches
SUITABLE FOR ALL INSTALLATION ON COMBUSTIBLE
FLOORS.
3.8 STAND INSTALLATION
Improper installation, adjustment,
alteration, maintenance or service can
cause death or injury or property damage.
Read the installation instructions completely
before installing, maintaining or servicing this
accessory.
Use of any replacement parts other than
those supplied by AccuTemp Products may
cause bodily injury, damage to property, and
damage to the equipment. Use of non OEM
parts will void all active warranties.
Do not touch this accessory while running
as the outside will be hot and can cause a burn
injury. Always wait until the accessory is cool
before servicing.
Griddles that mount to the this accessory
are heavy enough to require additional people
or powered assistance when installing. Failure to
do so can cause injury or death.
Operation of this accessory in an out of
level condition could cause poor performance of
the griddle that is mounted to it.
TOOLS REQUIRED:
Lifting device that is rated for lifting a
minimum of 500 pounds to a minimum
height of 26 inches
7/16” combination wrench
Inch pound torque wrench and 7/16” socket
1” Open end wrench or Adjustable wrench
Level
