12
the menu.
9. Factory setting (reset of all settings)
In this menu, the factory settings can be reset, i. all individually set values will be lost if you reset them
here.
To reset, press and hold the right knob until the countdown timer counts down from 5 to 0. When the
zero is reached, the amplifier switches off and all settings are reset to the factory settings (factory
setting). If the rotary knob is released before reaching zero, the reset is aborted.
By turning the left knob to the left you get to the menu in front of it. Press the left knob to exit the
settings menu.
8. Looking after your equipment
The ACCUSTIC ARTS
®
POWER I does not require special treatment in excess of the usual care taken with
high quality devices. Clean the housing with a dry or slightly moistened cloth. Please do not use any
aggressive detergents or detergents which contain silicon.
The best way to clean the chromed front plate is with a mild non-aggressive fat-dissolving detergent (e.g.
glass cleaner). Use a very soft clean cloth and wipe the front plate with this without exerting strong
pressure. Never use abrasive agents or polishing agents with abrasive particles.
IMPORTANT!
Do not place the unit in direct sunshine and avoid extreme changes in
temperature.
9. Troubleshooting
Malfunctions are mostly caused by something simple which can be put right quickly.
In the next section some possible malfunctions are described together with their corrective action.
However, if it is not possible to remove the malfunction please contact your authorized dealer.
Malfunction
The unit was switched on, the display remains dark.
Cause 1
The mains cable is not properly connected.
Solution
Check mains cable and push in firmly.
Cause 2
The FUSE
2
is damaged.
Solution
Pull out the mains plug and replace the corresponding fuse (see chapter
5. 8
).
Malfunction
The POWER I does not play
Cause 1
A fuse inside the unit is damaged.
Solution
Pull out the mains plug, carefully remove the housing cover and replace the respective
fuse. This replacement action must be carried out by the authorized dealer.
Cause 2
Clipping due to overload of the power amplifier.
Solution
Lower the volume by turning the rotary control
10
to the left
