AccuLine CNQplus 1000RT, User Manual

Page: 22 / 94

21
more than 1 second for the UPS to turn on, then the UPS will get into
will to turn on UPS, the LCD screen will indicate the status of the UPS.
Note: The default setting for bypass mode is no output after the UPS
is connected to the utility power and the breaker is turned on. This
can be configured through the UPS menu via the LCD panel or
firmware.
5.5 Test function
(1) Real time detection
The UPS will perform real-time detection when batteries are connected or
disconnected. If the battery connection status is changed during floating mode,
the UPS will detect the change within 30 seconds; During resting mode, the
UPS will detect the change within 3 minutes.
(2) Manual test
Test the function of the UPS system by pressing the On- for more
than 1 second, the UPS will immediately detect whether the battery is
connected or the battery is low. In addition, the UPS can be programmed to
perform this test automatically and periodically, the period time can be set by
user - the default setting is 7 days.
5.6 Turn off the UPS
(1) In Inverter Mode:
, the
UPS will get into no output or bypass mode. At this point, the UPS may still
have output if bypass is enabled. Disconnect the UPS from the utility power to
turn off the output.
(2) In Battery Mode:
, the
UPS will be turned off completely.
5.7 Audible alarm mute function
continuously for more than 1 second to silence it. The alarm will sound again
when the battery is low to remind you to shutdown the loads soon.