AT2T-3238-1 Rev. C
ACCU-STEAM
GAS GRIDDLE OWNERS MANUAL
Page
7/29
INSTALLATION (cont.)
ELECTRICAL REQUIREMENTS
The electrical voltage requirement is listed on the data plate that is located on the
front control panel. All standard AccuTemp gas griddles are supplied with power cord
and plug that must be connected to a standard 15 A (120 V) or 20 A (208 – 240 V)
grounded receptacle. Make sure that the voltage at your supply receptacle is within ±
10 % of the voltage listed on the griddle data plate. Connection to any other voltage
not identified on the data plate may cause damage to components in the griddle and
damage of this type is not covered under the warranty.
Ensure that the position of the wall receptacle is not in a high heat zone. Electrical
connections made in a high heat zone, such as just above, below or beside the griddle
exhaust flue, will cause plug and cord failures that will not be covered under the
warranty. It is recommended that the wall receptacle be positioned as low as State and
local codes will allow.
GROUNDING INSTRUCTIONS
Grounding provides a path for electric current to reduce the risk of shock. This
product is equipped with a power cord having a grounding conductor and a grounding
plug. The plug must be plugged into a receptacle that is properly installed and
grounded in accordance with all National, State and local electrical codes, or in the
absence of local electrical codes with
National Electric Code, ANSI/NFPA 70, or
the Canadian Code, CSA C22.2
as applicable. Under no circumstances shall the
plug’s round grounding prong be cut or bent to fit a receptacle other than the one
specified. A two-prong adaptor must never be used.
WARNING
This appliance must be properly grounded, in accordance with all National,
State and local electrical codes.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
