Accu-Sort AXIOM 400, Product Manual

Page: 79 / 132

AXIOM™ 400 Product Manual
Maintenance
6-7
06-AXIOM400-Maintenance_R10.doc Accu-Sort Systems, inc.
Verify Reader Operation
Follow the Operations Checklist procedure defined in Chapter 5.
If the Axiom parameters were changed to read bar codes other than the factory
defaults, simply use a good quality bar code to assist in verifying proper
operations. There is no need to return the reader to the default parameters to
perform this test.
Verify Photoeye Operation
1. Block the photoeye beam to confirm it is aligned properly with the
reflector.
2. If the LED on the photoeye changes status, the photoeye is functioning
properly.
3. Verify that the Trigger LED on Axiom is green when photoeye beam is
blocked.
4. If the photoeye’s LED does not change status, adjust the photoeye so that
it is properly aligned with the reflector.
5. If the Trigger LED on the Axiom is not green when the photoeye’s beam is
blocked, check the cabling between the photoeye and Axiom wiring base
for damage.
Verify Tachometer Operation
There are two ways to verify tachometer operations.
Use Axcess Setup Software
1. Connect Axiom to a PC.
1.
Start the Axcess setup software.
2. Go to Diagnostics > Axiom Monitor .
3. Verify the Belt Speed is accurate when the conveyor is running.
Use Tach LED in Wiring Base
1. Remove the scan head from the wiring base.
2. Slowly spin the tachometer wheel while verifying the tach LED in the
wiring base is flashing.