Accu-Sort AXIOM 400, Product Manual

Page: 65 / 132

AXIOM™ 400 Product Manual
Setup and Operations
5-5
05-AXIOM400-Setup_and_Operations_R10.doc Accu-Sort Systems, inc.
Table 5-2: Network LED during Normal Operations
Mode Description
Single TCP/IP Solid GREEN – Axiom connected to a host.
NOTE
: If both Host 1 and Host 2 are used, the LED will be solid
GREEN
if either port is connected.
Off – No host connection.
NOTE : If UDP messaging is used (unconnected messages) the
Network LED will be off.
EtherNet/IP Solid
GREEN
– Axiom made a connection to the PLC
Flashing
GREEN
– No connection made with the network
Flashing RED – Lost network connection
Controller/Client
Controller
Solid GREEN – The correct number of client(s) with the same
group number have been found.
Flashing
RED
– All the client(s) with the same group number
have NOT been found
Client
Solid
GREEN
– Connected to a controller with the same group
number.
Off – Not connected to a controller with the same group
number.
NOTE:
The mode indicated by the Network LED is dependent on the Axiom
configuration you are using. Ethernet/IP is the highest priority, Single TCP/IP mode
operation is the lowest.
Table 5-3: Using Control Panel Buttons to Check Normal Operations
Ref Button Description
A Upload to Axiom Uploads parameters from Wiring Base to Scan Head
ƒ Button must be pressed twice to initiate action.
ƒ The bar graph LEDs flash when pressed once.
ƒ The bar graph LEDs strobe from 1 to 5 when pressed
the second time, indicating the parameters are being
uploaded from the wiring base to scan head.
B Backup to Base Downloads parameters from Scan Head to Wiring Base
ƒ
Button must be pressed twice to initiate action.
ƒ
The bar graph LEDs flash when pressed once.
ƒ The bar graph LEDs strobe from 5 to 1 when pressed
the second time, indicating the parameters are being
backed up from the scan head to the wiring base.
C Test /Diagnostic Enables the Axiom test mode.
(Test mode can also be selected remotely using Axcess
Tools > Axiom Commands > Test Mode .)
REMEMBER
: Axiom’s control panel buttons can be enabled/disabled through
the use of the Axcess setup software. (Reference Axcess Software Manual. See
Modify > Axiom Configuration, Enable Axiom Control Panel Buttons.)