EXS-210 STEREO MICROSCOPE
ACCU-SCOPE
®
5
ASSEMBLY
Your stereo microscope comes pre-assembled. Optional eyeguards are included with your microscope
and can be installed on the eyepieces to help block out extraneous light.
ADJUSTMENT & OPERTATION
Voltage Check
Confirm that the input voltage indicated on the rear label of the
microscope corresponds to your line voltage. The use of a
different input voltage than indicated will cause severe damage
to your microscope.
Connecting the Power Cord
(Fig. 1)
Make sure the ON/OFF (I/O) switch
①
is turned to the OFF (O)
position. With the microscope facing away from you, make sure
the illuminators are turned off.
To turn the illuminators off: for the bottom illuminator
– the dial
on the left side of the microscope
②
should be turned all the
way toward the front of the microscope (or away from you); for
the Top illuminator
– the dial on the right side
③
of the
microscope should be turned all the way toward the back of the
microscope (or toward you).
Insert the power cord into the power receptacle on the back of
the microscope
④
; make sure the connection is snug.
Plug the other end of the power cord into the power supply
receptacle.
Input: 100V
～
240V, 0.15A; 50/60Hz
Output: 4.5V DC; 1000mA
Adjusting Interpupillary Distance
(Fig. 2)
Different users have different interpupillary distances (this
distance is between the centers of pupils of each eye). When
operators of the microscope change, it will be necessary to
adjust interpupillary distance.
While looking through the eyepieces, hold the left and right
eyepiece tubes
①
of the binocular assembly
and adjust the
eyepiece tubes by opening or closing them until the left and right
fields of view coincide completely and you are able to see a
complete circle.
Fig. 1
①
③
②
④
Fig. 2
①
