System Configuration
5-64
CLI Commands for WPA Pre-shared Key Security – From the
802.11a or 802.11g interface configuration mode, use the
authentication
command to set the access point to “Open
System.” Use the WEP
encryption
command to enable all types
of encryption. To enable WPA to be required for all clients, use the
wpa-clients
command. Use the
wpa-mode
command to enable
the Pre-shared Key mode. To enter a key value, use the
wpa-psk-type
command to specify a hexadecimal or
alphanumeric key, and then use the
wpa-preshared-key
command to define the key. Then disable 802.1x and MAC
authentication. To view the current 802.11g security settings, use
the
show interface wireless a
or
show interface wireless g
command (not shown in example).
AP(config)#interface wireless g
6-70
Enter Wireless configuration commands, one per line.
AP(if-wireless g)#authentication open
6-94
AP(if-wireless g)#encryption 128
6-95
AP(if-wireless g)#wpa-clients required
6-102
AP(if-wireless g)#wpa-mode pre-shared-key
6-104
AP(if-wireless g)#wpa-psk-type alphanumeric
6-106
AP(if-wireless g)#wpa-preshared-key ASCII asecret
6-105
AP(if-wireless g)#end
AP(config)#no 802.1x
6-52
AP(config)#no mac-authentication
6-58
Summary of Contents for WA6102X
Page 27: ...Hardware Installation 2 4 ...
