Operating
25
Engl
is
h
4.4.2
Using the upper section only
Figure 15: Webbing upper section.
1.
Remove the image guide.
2.
Unwind the film from the upper or top unwind roll.
Feed a film without release liner over the splitter bar (A).
Feed a film with release liner underneath the splitter bar (B).
3.
Pull the film forward until approximately 10 cm (4 in.) is on the in-feed table.
If the film has a release liner:
Peel off the release liner.
Pull the release liner up and stick it to the tube on the wind-up position.
4.
Stick the leader panel to the film and feed the panel into the nip using slow mode.
Note:
Use a carrier board when processing thin images.
4.4.3
Upper and lower section
Figure 16: Upper and lower section webbed.
4.4.3.1
The film in the upper section is webbed first
1.
Feed the film underneath (B) the splitter bar (between splitter bar and upper roller)
Film without a release liner must be fed over the splitter bar (A).
