12
I N S T A L L A T I O N
POWERING OFF THE PROJECTOR
1
Press the “Power/Standby” button to turn off the projector lamp, you will see a
message “Power off the lamp? Picture Mute” displayed on the projector’s screen.
Press the “Power/Standby” button again to confirm, otherwise the message will
disappear after 5 seconds.
Please note that if the
key is pressed instead, the projector will enter the
“Picture Mute” mode and no image will be displayed. To exit the “Picture Mute”
mode, press the “Power/Standby” button again.
2
The cooling fans continue to operate for about 60 seconds for cooling cycle and
the “Power/Standby” button will turn orange. When the light begins flashing, the
projector has entered standby mode.
If you wish to turn the projector back on, you must wait until the projector has
completed the cooling cycle and has entered standby mode. Once in standby
mode, simply press “Power/ Standby” button to restart the projector.
3
Disconnect the power cord from the electrical outlet and the projector.
4
Do not turn on the projector immediately following a power off procedure.
Warning Indicator
When the “LAMP” indicator lights solid red, the projector
will automatically shut itself down. Please contact your
local reseller or service center.
When the “TEMP” indicator lights solid red for about 20
seconds, it indicates the projector has been overheated.
You will see a message “Projector Overheated. Lamp
will automatically turn off soon.” on the on-screen
display. The projector will automatically shut itself
down. Under normal conditions, the projector can be
switched on again after it has cooled down. If the
problem persists, you should contact your local dealer or
our service centre.
When the “TEMP” indicator flashs red for about 10
seconds, you will see a message “Fan fail. Lamp will
automatically turn off soon” on the on-screen display.
Please contact your local dealer or our service centre.
