Acclaim Lighting AJBOX1, User Manual

Page: 9 / 20

7
2 If required, gently prise off the rubber seals from the
blanking plugs using a small flat blade screwdriver
in order to install them on the cable glands/conduit
fittings that you’re using:
4 Space is quite tight within
the box so it is advisable to
release the two connector
blocks in order to make
them more accessible.
Use the #2 Phillips driver
to loosen the four screws
holding down the connector
blocks (there is no need
to remove the screws
completely).
5
Ensure that the incoming
AC power is fully isolated.
Prep the AC input cable (as
shown on page 4), then
insert it through your cable
gland/conduit fitting and
into the marked
AC IN
hole.
As space is tight within
the box, we recommend
that you do not screw the
gland/fitting into the box
at this stage so that the
cable can be more easily
manipulated.
3 If required, place the rubber seals removed above onto your cable glands/conduit fittings.
AC input cable
via 3rd-party
conduit fitting or
cable gland