Acclaim Lighting AJBOX1, User Manual

Page: 12 / 20

10
8 Prep the output feed cable (as shown on pages 4 and 5), then insert it through
the large cable gland and into the ¾“ access hole. Once again, we recommend that you
do not screw the gland into the box at this stage so that the cable can be more easily
manipulated.
9 In turn, insert the six output feed wires into the AC power and control connector blocks,
taking great care to ensure that the various wires are mated only with the correct
terminals (see pages 4 and 5 for wire designations):
For each input:
a Press down on the lever (to open the
internal spring contacts).
b Carefully push the correct wire into
either of the adjacent holes until the
bare conductor goes all the way in.
c Release the lever and check, by
gently pulling the wire, that it is
correctly seated and retained.
Control
connector
block
AC power
connector
block
Supplied cable
gland or optional
box connector
(¾“ NPT thread)
DMX control