background image

 

 

ACCES I/O Products, Inc. 

MADE IN THE USA 

mPCIe-ADIO16-16F Family Manual 

 

13 

Rev B1f 

 

GENERAL 

Under this Warranty, liability of ACCES is limited to replacing, 
repairing or issuing credit (at ACCES discretion) for any products 
which are proved to be defective during the warranty period. In no 
case is ACCES liable for consequential or special damage arriving 
from use or misuse of our product. The customer is responsible for 
all charges caused by modifications or additions to ACCES 
equipment not approved in writing by ACCES or, if in ACCES opinion 
the equipment has been subjected to abnormal use. "Abnormal 
use" for purposes of this warranty is defined as any use to which the 
equipment is exposed other than that use specified or intended as 
evidenced by purchase or sales representation. Other than the 
above, no other warranty, expressed or implied, shall apply to any 
and all such equipment furnished or sold by ACCES. 

TERMS AND CONDITIONS 

If a unit is suspected of failure, contact ACCES' Customer Service 
department. Be prepared to give the unit model number, serial 
number, and a description of the failure symptom(s). We may 
suggest some simple tests to confirm the failure. We will assign a 
Return Material Authorization (RMA) number which must appear on 
the outer label of the return package. All units/components should 
be properly packed for handling and returned with freight prepaid 
to the ACCES designated Service Center, and will be returned to the 
customer's/user's site freight prepaid and invoiced. 

 

COVERAGE 

FIRST THREE YEARS: 

Returned unit/part will be repaired and/or 

replaced at ACCES option with no charge for labor or parts not 
excluded by warranty. Warranty commences with equipment 
shipment. 

FOLLOWING YEARS

: Throughout your equipment's lifetime, ACCES 

stands ready to provide on-site or in-plant service at reasonable 
rates similar to those of other manufacturers in the industry. 

EQUIPMENT NOT MANUFACTURED BY ACCES  

Equipment provided but not manufactured by ACCES is warranted 
and will be repaired according to the terms and conditions of the 
respective equipment manufacturer's warranty. 

DISCLAIMER 

The information in this document is provided for reference only. 
ACCES does not assume any liability arising out of the application or 
use of the information or products described herein. This document 
may contain or reference information and products protected by 
copyrights or patents and does not convey any license under the 
patent rights of ACCES, nor the rights of others. 

PCI EXPRESS MINI CARD STANDARD NOTICE AND EXCEPTION 

The mPCI-DIO-24S family of devices are fully compliant with PCI 
Express Mini Card v1.2. 

Summary of Contents for mPCIE-ADIO16-8F Series














Reviews: