Assembly Instructions / Turbochargers A150-M.. - A155-M..
4 Installing the turbocharger / 4.2 Placing the turbocharger on the bracket
© Copyright 2023 Turbo Systems Switzerland Ltd. All rights reserved.
HZTL455311P0006_EN
Rev. D
April 2023
Fig. 6: Fitting the turbocharger 2
Product
Value X
Value L
A150
112 ±2 mm
52 ±2 mm
A155
144 ±2 mm
72 ±2 mm
Table 5: Fitting the turbocharger, value X, L
Step C – Aligning the turbocharger on the bracket
1.
Lightly lubricate the hole, into which the centering bush (42193) is inserted, with screw grease.
2. Position threaded rod with centering bush in the bracket.
3. Insert centering bush into bracket until the stop is reached.
4. Carefully lower turbocharger onto bracket and position using the centering bushes (42193) loc-
ated in the bracket.
5. Check value x.
u
If value x is not reached, the turbocharger must be lifted up from the bracket and realigned.
Step D – Fixing the threaded rod in place in the bracket
u
Using the hexagon, screw the threaded rod into the bracket up to value L.
u
If value L is not reached or the threaded rod jams while being screwed in, the threaded rod must
be loosened by no more than ½ revolution (this will loosen the centering bush which may have
jammed the rod). Then continue screwing in the threaded rod.
u
If value L is not reached, undo the screw connection, carefully take the turbocharger off the
bracket and repeat the procedure starting with Step A.
u
Observe the instructions for fastening the turbocharger with clamping nuts (see chapter
the turbocharger with a clamping nut
).
Page
12
/
21
Summary of Contents for A100-M radial
Page 2: ......
