24
2. Insert fi xed long frame support into the long adjuster mid-section end closer to the adjustment
handle. Align the thru holes on each end and insert a T-Handle pin to attach both.
Fixed Long Frame Insert
T1H2 Long Adjuster
Mid-section
T-Handle Pin
3. Align the center numbered tube #1 thru hole and one end of the center tube shown and insert
the T-Handle pin (Part #95545) far enough until the handle cannot slide out freely. Remove
the T-Handle Pin on the side with the adjustment handle and leave out until the tug’s width
has been adjusted to the previously measured width. This connection does not adjust and
will remain intact when adjusting the width of the T1H2 tug. Facing down on the adjustment
handle turn it counter-clockwise until it can no longer turn.
#1 Thru Hole
Figure 1
Adjust to number on front
T1H2 Short Adjuster Mid-Section
Figure 2
Figure 3
*Length will vary
*Length will vary depending on the T1H2 short adjuster*