abyzz AFC400, User Manual

Page: 11 / 30

!
Electrical connection:
The Abyzz driver requires a voltage of 230V / 50 ... 60Hz or 100-120V / 50 ... 60Hz
(US variant).
The connection has to be carried out on a suitable, properly installed, protective
contact socket, which is fused via a circuit breaker according to DIN VDE
0100T739 (residual current circuit breaker). We recommend not connecting more
than 4 controllers to one supply line (16A fuse).
If a fuse is defective, replace it with fuses of the same type.
400 W models 250V 8A T
The product has two separate fuses and a main switch, which are accommodated
in the connector element. To remove the fuses, the power plug of the Abyzz power
cable must be removed. The cold plug is equipped with a locking mechanism to
prevent it from falling out. Press the red lock button (P2) on the power connector
and pull out the connector. You can then remove the fuse drawer (P1) and replace
the fuses.
Installation of pump
The Abyzz pump can only be operated up to a depth of 0.5-8 meters. The
mounting can be carried out via the optionally available accessories, please
contact our sales department (info@abyzz.de). Installation must be carried out by
qualified personnel.
Quick start
After proper installation, the Abyzz pump can be put into operation. Connect the
motor cable to the driver. The plug is coded and can only be connected in one
position. The plug used meets the highest requirements for tightness and safety.
Screw the plug to ensure these characteristics. Connect the Abyzz power cable to
the driver and plug the power plug into a suitable grounding box and turn on the
main switch.
The LED is flashing. You can start and stop the pump in any mode by pressing the
Start / Stop button.
If the pump suddenly becomes dry with more than 40% of its capacity, the dry-
running warning is activated. This switches off the pump and signals an error
("DRYRUN!" And acoustic signal). After a few seconds, the pump starts running
again and resumes its operation.
! 11