abyzz A100, Operating Manual

Page: 24 / 32

Technical changes
Due to the constant further development of our products and to innovations that, in
particular, serve to improve quality, safety, and technical progress, the
manufacturer reserves the right to make technical changes.
Troubleshooting
If, despite the high
standard of quality, faults should occur, please use the
checklist below to rectify or restrict the problem. A number of faults are already
detected and displayed by the electronics.
Malfunction Cause Remedy
The display does not light
up and the LED flashes
a) Screensaver on a) Press a button
The display does not light
up and the LED does not
flash
a) No mains voltage a) Check the mains
connection
If the fault cannot be rectified,
there is a driver fault. In this
case, please contact the
service team.
Status: COMM FU! a) Control unit communications
failed
a) Switch off the device and
switch back on after 10
seconds
Status: Imax! a) Overcurrent fault, motor
overloaded
a) Check motor to make sure
that it can move freely
Status: MOTOR? a) Motor not detected a) Check connection to motor,
check plug
Status: TEMP! a) Driver overheated a) Let the driver cool down,
lower the ambient
temperature
Status: DRYRUN! a) Motor has run dry or is drawing
in air
a) Check the water level,
check the pipes for leaks
Status: LOW VOLT! a) Mains voltage too low
b) Too many devices on one lead
c) Mains lead too long
a) Check the mains voltage
b) Reduce the number of
devices
c) Reduce the length of the
lead, remove multi-socket
strips
Device is working but cannot
reach maximum power
If you cannot rectify the fault by checking the lines (incorrect connections), mains
voltage, and pump (smooth running, blockages), please contact your specialist
dealer. In such cases, please be ready to state the serial number of the driver and
of the motor. The serial numbers are on the blue serial number sticker or on the
packaging.
24