[35]
wAppLoxx Pro Control Complete Instructions
7. Cascading wAppLoxx Pro Controls
Cascading two wAppLoxx Pro Controls
You can use the cascading function to connect two wAppLoxx Pro Controls in the master-
slave mode of your local network. The master-slave function is used to increase the range of
the wireless coverage. wAppLoxx Cylinders are thereby directly programmed into the master
or slave control. Account management is only carried out at the system master control. All
data such as user, locking plan, etc. are transferred from the master control to the slave
control.
Setting up a master/slave system
Following the sequence of installation steps in order as well as a good network
communication between the master and slave control are required for smooth
operation.
1. Connect both wAppLoxx Pro Controls to your network, establish the power supply and
connect to both controls using the wAppLoxx Pro Finder. Both wAppLoxx Pro Controls
are in standalone mode by default (single operation).
2. Before setting up a cascaded system, carry out a complete factory reset on both
wAppLoxx Pro Controls. No cylinders or users may be registered in the Controls at this
point.
3. Before setting up the cascade, make sure that both Controls have the same firmware
version and carry out a firmware upgrade if required.
4. Configure the basic settings (language, time, network settings, etc.) on both wAppLoxx
Pro Controls and copy/make a note of the IP address of the desired slave control. You
can view it on the dashboard:
5. Program a cylinder/wall reader in the future master control now and program it as a
reader to scan locking media.
