7
English
1.3. Operating principle
The device was developed for use in alarm and home automation systems that use the Z-Wave wireless
standard. The device has the following functions:
Motion detector
It uses Passive Infrared (PIR) technology to detect movement in a defined area by detecting the
changes in thermal radiation caused by the moving body inside or outside the detection zone.
With the dual PIR sensor (dual-lens technology), the sensor hides pets up to approx. 38kg, so
that your pet can move freely without triggering the sensor.
When the motion detector is triggered, an alarm signal is sent to the Z-Wave controller. The
indicator LED lights up when motion is detected.
Integrated temperature and humidity sensor
At periodic intervals, the unit automatically sends the measured temperature and humidity value
to the Z-Wave controller or on request of the Z-Wave controller.
Tamper protection between the device and wall bracket
When the housing is opened, the tamper switch is triggered and the device sends a tamper
alarm to the Z-Wave controller. The tamper contact must remain pressed for three seconds to
reset the tamper alarm.
1.4. Performance features
The device..:
...is a battery-powered motion detector
...is due to its design only suitable for wall mounting
...is Z-Wave Plus compatible & certified
...supports the Z-Wave S2 standard (Security 2)
...has a low-battery warning function
...was developed for indoor installation
1.5. Use in systems of different manufacturers
Communication is via the Z-Wave EU frequency (868.4 Mhz). You can integrate the device into any Z-
Wave network with a certified Z-Wave controller, regardless of manufacturer. All non-battery powered
nodes in the network act as amplifiers to amplify the wireless communication of the network.
1.6. DSK code
The DSK code (Device-Specific Key) is the device-specific key of your device and is required for secure
teach-in (inclusion) via S2 on the Z-Wave controller. The first 5 digits of the DSK code can be found on
the QR Code sticker on the backside of the bracket of the product. Please enter them in the inclusion
process when prompted. Alternatively, you can transfer the entire DSK code that you find on the
enclosed DSK card to the Z-Wave controller via QR Code Scan. Please keep the DSK card in a safe
place!
Hint:
We recommend the secure S2 inclusion (must be supported by the Z-Wave controller) When prompted,
please enter the 5 digits of the DSK code (bottom of the device) or the complete DSK code (QR code).
