Abus FUBE50000, Installation And Operating Instructions Manual

Page: 33 / 200

Installation and start-up
33

If DIP switch 6 (chip key reader) is activated when the control panel starts
up, the status LED for partition 1 will flash green during chip key reader
calibration.

If DIP switch 6 (chip key reader) is deactivated when the control panel
starts up, calibration will be performed as soon as the DIP switch is
activated.

Keep the chip key and any other metal objects away from the chip key
reader during calibration to avoid disrupting the process.

If the tamper contact is open when the control panel starts up, the
following LED test will be performed:
(1.) All four status LEDs flash red
(2.) The transmitting LED (RF TX) located on the PCB lights up
(3.) The test LED (TEST) lights up
(4.) The SW version of the control panel is indicated by the RF TX LED

If the tamper contact is closed when the control panel starts up, the
aforementioned test will not be performed.