11
•
Make sure to maintain working pressure across ozone cell as specified for
the generator protection and most efficient ozone production.
•
When injecting ozone in to water make sure to protect the generator from
flooding by installing device capable of preventing water backup. Check
valves usually start leaking after few days of operation in ozone and
cause serious damage to the ozone cell. We recommend using devices,
which could automatically drain water out of ozone line and stop it from
entering the ozone cell.
•
Protect internal components of the Ozone Generator from water, snow,
excessive dust and humidity, vibration, mechanical shock; make sure that
there is a sufficient amount of clean air available for the unit cooling air
and inlet and outlet are not obstructed by other equipment or elements.
•
Check that electrical power fluctuations are /- 10% of the
specified AC Voltage and install power-conditioning devices if necessary.
SECTION 4
–
Maintenance and Service
4A. Preventative Maintenance
Generally the ATLAS/TITAN/MAGNUM 25-200 are maintenance-free although it
is useful to check the Ozone Generator for proper operation:
a.
Make sure green indicator light is lit during operation.
b.
Red light or Amber light for Magnum is off
c.
Make sure that all air vents are clear of any obstruction.
On a monthly basis:
1.
Make sure that all system equipment (oxygen concentrator, air
compressor, etc.) is maintained according to the manufacturer
recommendations.
2.
Remove and replace or clean filter cartridges and other devices if installed
and required.
3.
Perform general cleaning of cabinet exterior after disconnecting the
equipment from electrical source.
4.
Using clean/dry compressed air, blow out the interior of cabinet, taking
special care around electronic components and wiring.
4B. Troubleshooting
Knowledge of electrical applications is required for troubleshooting. Contact a
certified electrician if you are unsure of your ability to service the equipment. If