Specifications:
o
Battery Type:
LiPo/LiFe (2-3 Cells) and NiMH/NiCd (1 – 8 Cells)
o
Charge Current:
1/3/5 A (max. 50W)
o
Input:
230V
o
Balance Plug System (2S/3S):
XH(R)
o
Balance Current:
350mAh
o
Measure (L/W/H):
110 x 109 x 49 mm
o
Weight:
490 g
Instruction manual:
•
Please connect the charger to a 230V mains socket. The status LED lights up green.
•
Use the slide switch to select your battery type (LiPo, Li-Fe or NiMH/NiCd).
o
"Li-Po" for a 1 to 3 cell Li-Po/LiFe rechargeable battery
o
"NiMH/NiCd" for a 1 to 8 cell NiMH/NiCd rechargeable battery
•
The LED confirms the selected battery type as follows:
o
LiPo battery = red LED
o
LiFe battery = orange LED
o
NiMH/NiCd battery = green LED
•
Use the slide switch 1A, 3A or 5A to select the appropriate charging current.
Our recommendation:
(ATTENTION: It is essential to observe the maximum charging current permitted by the battery manufacturer!)
Charging Current
NiMH/NiCd
LiPo/LiFe
1A
up to 1000mAh
up to 2000mAh
3A
1000 bis 2000mAh
2000 – 4000mAh
5A
more than 2000mAh
more than 4000mAh
•
Connect the battery plug to the charger (for LiPo batteries, always connect the balancer plug first!). Pay attention to the
correct polarity (+ / - colour-coded)
•
The LED lights up RED during the charging process.
•
When charging is complete, the LED lights up GREEN again.
•
If the LED flashes RED, check that all settings are correct and that all cables (charging cable, balancer cable) are properly
connected. If the LED flashes despite all this, the battery appears to be damaged and should never be used again. In this
case, dispose of the battery properly.
•
Remove the battery from the charger when charging is complete.
LED for
battery-type and status
Charging output
4mm sockets for
charging cable
LiPo balance connector for
2S (2-cells) LiPo/LiFE and
3S (3-cells) LiPo/LiFe batteries
Switch for LiPo/LiFe or
NiMH/NiCd batteries
Socket for temperature sensor
(not included in delivery)
Switch for charging current
1A / 3A / 5A
