Absco Industries
Assembly Instruction Manual
ABSCO COMPACT GARAGE
MODEL: CG56552N2
5.64m W x 5.49m D x 2.64m H
Model: CG56552N2
16/10/19
24
Roof Sheets Fitting
Pan
Turn pans up
Length of hardwood with
25mm deep saw cut, used
to bend pans of sheets.
Roof sheets to
with front and rear wall
sheets
1
2
3
4
5
6
7
8
Overlap last sheet by
three pans
• Lay the roof sheets on the ground in the same configuration as shown. This will prevent rainwater
entry during windy conditions.
• Fit the roof sheets in the same manner as the wall sheets. Each sheet should be in line with the
side wall sheets, and overhang 30mm to allow rainwater to flow into gutters.
• Working from inside the garage using a ladder or safety platform, secure each sheet as shown,
with the first sheet flush with the front gable sheets.
• Use one screw with neo washer at every pan to ridge and outer purlins. Use one screw with neo
washer at every second pan on the center purlin.
• Repeat the above procedures for the other side of the roof.
Fit Ridge Capping
• Working from the garage towards the center, lay the ridge capping on the ridge pf the roof
sheets, overlapping sections to attain the required length. Secure to every second rib of the roof
sheeting with screws and neo washers .
Note: Avoid walking on the roof so the sheeting does not get damaged. If it is necessary, walk only
on the sheet pans at ridge purlin locations, after all sheets have been fully fastened to the framework.
To avoid damage or injury, wear a safety harness and move along the ridge on your hands and
knees.
8 sheets per side.
286