DOOR PANEL ASSEMBLY
NOTE: The two holes required to connect the padbolt hasp for each door have not been pre-punched, to allow for
proper alignment. position each hasp centrally over the padbolt shaft, and drill 3mm holes and secure with screws
NOTE: Nuts and bolts (supplied) may be used instead of
pop rivets (supplied) by simply enlarging the hinge hole
sets in the jamb using a 4mm drill bit
ABSCO INDUSTRIES
ASSEMBLY INSTRUCTION - MODEL: 45232WK 24/02/17
91A
91A
A
B
Absco Workshop Shed
Model: 45232WK
PAGE 22
