4
THE CARRIER IS YOUR SOLE SOURCE FOR SATISFACTION OF A DAMAGE CLAIM. UNDER NO
CIRCUMSTANCES SHOULD THE MERCHANDISE BE RETURNED TO THE
MANUFACTURER. NO RETURNS WILL BE ACCEPTED WITHOUT PRIOR
AUTHORIZATION.
INSTALLATION
UNCRATING – Move your new unit as close to the final location as
possible before unpacking. Remove the wooden planks or skid.
The location should be as close as possible to the power outlet
so an extension cord is not needed. This unit requires a
minimum of 4 inches of air flow space in back and 3 inches on
the sides and top. Do not store material on the top of this
unit.
PLEASE NOTE! Your refrigerator/freezer is designed
for INDOOR USE and should be operated in an air conditioned
space with temperature between 65°F to 85°F.
LEVELING
You can level your unit with the screw-type adjustable leveling legs on the front
corners of the unit. Turn counterclockwise to raise the corner; turn clockwise to lower it.
Leveling legs are required in front only. Unit may have a slight tilt from front to back after
legs are installed. This is acceptable and is recommended on this unit.
POWER SOURCE – The supply circuit to this cabinet must
conform to all National and Local Electrical Codes.
Consult the cabinet Serial-Data plate for voltage, cycle,
phase, and amp requirements before making connection.
VOLTAGE SHOULD NOT VARY MORE THAN 5% FROM
SERIAL PLATE RATINGS. A separate circuit is
recommended to prevent possible loss of product due to
over-loading or failure of other equipment on the same circuit. PROTECT THE CIRCUIT WITH
A 20 AMP DELAY-TYPE FUSE OR CIRCUIT BREAKER. Do
not use an extension cord. Be sure your unit is properly
grounded. Use the 3-prong plug provided into a 3-prong
grounded outlet. (Only this method complies with
national electrical codes, local codes and ordinances.)
Unless the above grounding method is followed, you are
not protected against severe or lethal shock in the event
of a short circuit of an electrical component or wiring of
the unit.
STARTING – There are no compressor shipping bolts to
loosen or valves to open. All that is necessary after the
unit has been properly leveled is to plug the service cord into an electrical outlet When
