![background image](http://html1.mh-extra.com/html/abs/abt-23ss-gp/abt-23ss-gp_owners-manual_3517129005.webp)
Part number 20080, Rev 0
5
STARTING
There are no compressor shipping bolts to loosen or valves to open. All that is necessary after
the unit has been properly leveled is to plug the service cord into an electrical outlet When
starting this new appliance, allow the cabinet to operate a minimum of eight hours or until it
has started cycling normally before placing product in the cabinet. The motor compressor may
start and stop several times when the unit is first started or after defrosting, especially if the
weather is very hot. This is only normal functioning of the motor overload protector. The
motor compressor will cycle normally as soon as the excess heat has been removed.
SHELF INSTALLATION
Hook shelf clips onto pilaster strips (see Illustration). Position all four shelf clips equal in
distance from the floor for flat shelves. Wire shelves are oriented so that cross support bars are
facing down. Place shelves on shelf clips making sure all corners are seated properly.
TEMPERATURE CONTROL
NOTE: The control is preset at the factory to provide the desired air and
product temperatures inside of the unit and requires no further adjustment.
Please contact the manufacturer’s Technical Service Department
before making any adjustments to determine if adjustment is necessary and, if
so, to make sure it is performed properly.
The temperature in the refrigerator is controlled by an electronic temperature controller located on the
front of the unit above the door on the right hand side. The operation of this controller is discussed
beginning on page 7 of this manual.