LED LEOPARD SERIES MINI FLOOD & WALL LIGHT
Instruction Manual
Add:
1501 Industrial Way N, Toms River, NJ 08755
Phone:
866-222-8866
E-mail:
Web:
www.AboveAllLighting.com ©2016 ABOVE ALL. Inc. All rights reserved
2
Ref#: 1
1096-21013
OPTION 1: TRUNNION
INSTALLATION
OPTION 2: KNUCKLE
INSTALLATION
OPTION 3: JUNCTION BOX
INSTALLATION
1. Mount luminaire to surface using the hole pattern
provided on the trunnion bracket. Recommend 1/4”-20
lag bolts and washers (supplied by others).
2.Make electrical connections from the trunnion cord to
the supply wiring as above wiring digram. Be sure to
use an appropriate weather-tight seal at the trunnion
cord entry point (not included.)
3.Adjust the aiming angle of the fixture by loosening the
pivot screws and lock screws on the trunnion bracket
and rotating the assembly to the desired angle. Re-
tighten the pivot and lock screws to ensure that the
fixture is not loose.
Body
Wire
M4*10 Screw
Trunnion
Waterproof Joint 1/2 NPS
1.Loosen the knuckle center screw. Adjust the position of
the knuckle stem. Re-tighten.
2.Route electrical leads through the 1/2” NPS access
hole in cover plate (supplied by others). Secure cover
plate to knuckle with lock nut.
3.Make electrical connections as above wiring digram.
4.Push wires into junction box and install cover plate
(with luminaire attached) to the junction box.
1.Open connection box, mount luminaire to wall by drilling
(2) holes on the junction box as Fig.2 shown
2.Make electrical connections in the connection box as
above wiring digram.
3.Screw the cover tightly
4.Adjust the direction of the body by loosening the pivot
screws on holder. Re-tighten the pivot and lock screws to
ensure that the fixture is not loose.
Knuckle
Body
1/2 NPS Nut
Wire
Knuckle
center screw
Body
Wire
Holder
1/2 NPS Block
Connection Box
Waterproof Joint
Connection Box Cover
Fig. 1
Fig. 2
