Installation manual
Superbike
™
for Kawasaki Ninja H2 SX 2018-
• Revision: 00 • 13/02/2019 •
© ABM Fahrzeugtechnik GmbH
Page 7 of 8
Stick on the left-hand rubber grip.
Before the final fixing of the handlebar and
the armatures, make sure that the handlebar
does not come into contact with any other
parts (e.g. fairing or tank), even in maximum
steering angle.
Attach the clamps.
Tightening torque 21 Nm
The cable harnesses of the armatures are run
in front of the fork.
Reattach all previously removed parts.
The final assembly of the operating elements
requires the drilling of holes for the centring
pins. To do this, align the operating elements
and mark the positions for the centring pins
(push onto the pins using grease). Now,
centre-punch the marked position and drill a
hole (diameter and depth are based on the
centring pin).
4
Final check
Make sure that all operating elements present on the handlebar are adequately positioned,
even in maximum steering angle. The brake pump and the reservoir must be located in an
adequate operating position.
Pay attention to the freedom of movement of the handlebar, its mounted parts and adequate
steering angle to each side. The handlebar must be able to be moved easily to the maximum
steering angle on both sides. Check the free play of the accelerator and clutch cables: In
maximum steering angle to both sides and with the engine running, the motor speed must
not change.
