Installation manual
Superbike
™
for Kawasaki Ninja H2 SX 2018-
• Revision: 00 • 13/02/2019 •
© ABM Fahrzeugtechnik GmbH
Page 2 of 8
Caution
Important safety advice:
Work undertaken on the steering and the brake system poses a safety risk. This work may only
be carried out by appropriately qualified personnel. Faulty work can have serious consequences
and may pose a threat to life and health. Only undertake this installation if you are sufficiently
qualified and have an official workshop manual as well as all relevant service notifications
available. Otherwise, we strongly recommend that the installation is carried out or at least
checked in a specialist workshop.
Brake fluid is toxic and may damage the surfaces of the fairing and other components. Use
suitable means to protect all parts against damage. Please observe the safety information of the
brake fluid manufacturer.
Use only fresh brake fluid taken from a sealed container. Always use new sealing rings which
comply with the specifications of the brake lines manufacturer. Never combine copper sealing
rings with aluminium fittings.
ABS brake systems should be bled solely in a garage authorised by the vehicle manufacturer.
Any work in relation to the installation, removal and tightening torque of original parts should
always be carried out in compliance with the workshop manual.
To ensure safe function, it is essential that all contact areas of clamp connections are clean, dry
and damage free during installation. Important: Make sure that nothing gets onto these contact
surfaces which decreases friction
(e.g. oil, silicone, care products, etc.).
It is essential that all clamp screws are tightened with the specified torque. The torque
specifications refer to dry screws and threads. The tight fit of all screw connections must also be
checked at every inspection.
It is your responsibility to check the product regularly and to determine if a service or
replacement is required.
Please remember that the yokes are safety-relevant parts of your vehicle. Check the handlebar
as well as the risers and yokes after a fall or collision and replace them completely at the
slightest indication of damage.
Never tie down the vehicle at the handlebar.
The
Superbike Kit
requires registration.
This product has been designed for a standard vehicle. ABM® Fahrzeugtechnik GmbH makes no
warranty or guarantee of any kind for any damages whatsoever arising out of the combination
with other component parts not tested by ABM, as a consequence of improper installation or
inadequate maintenance.
