Ap1400 Installers’ Guide Page 11 of 16
10.3 MOUNTING BRACKET
1) Fit the printer into the panel and apply the mounting bracket as shown below.
2) Secure with two M3 machine screws or two cable ties, one at either side of the bracket. (all
included in Ap1400KIT).
3) Open the lid of the printer, fit a paper roll and close the lid.
4) Connect power and data leads as described in the ‘
Connection Guide’
in this document.
10.4 FIXING ORIENTATIONS
Ideally, the fixing orientation of the Ap1400 host panel should permit the free rotation of the paper roll
in normal operation and its retention when the paper compartment is opened. The printer can
therefore be mounted horizontally or angled to the limits shown below.
Should you wish to use the Ap1400 in orientations that exceed these limits please contact Able
Systems for advice.
10.5 LOCATING THE PRINTER
NOTE: The Ap1400 is a thermal printer and care should be taken to
ensure that the printer and the paper it prints to are not subjected to
extreme temperature or humidity
NOTE: The Ap1400 is an open-framed printer. It is the installer’s
responsibility to ensure the enclosure into which the printer will be
fitted confers suitable protection from environmental factors and
electrical and physical interference, as well as preventing user
access behind the face of the panel.
