Voice dialing
This is it. The AP-7000 is now ready to listen to your voice and dial. Please follow these easy steps to
dial:
A. Command the phone. At the prompt, say the name you wish to call.
B. The AP-7000 will playback the recognized name and will dial the corresponding number.
C.
At the end of the call, the command and the AP-7000 will hang up.
Please also note these following general important remarks
:
A. You can disconnect the AP-7000 from the power if needed. The names and numbers will
not be lost and your phone will continue to operate normally.
B. If you are using a cordless phone, please verify that the line is ‘clean’ with no ‘white’
noises. These ‘white’ noises, usually occurring when the mobile part of the cordless
phone is far from its base, can cause difficulties in recognizing names for the AP-7000.
C. Switching to the main menu from the ‘name to dial’ menu. Once the memory has at least
one name stored in it is done in the following way:
D. Command the phone.
E. After the AP-7000 prompts you for a name to call, press the ‘#’ key.
F. If you want to manually dial a number from the keypad do the following:
G. Pick up the handset. After the AP-7000 prompts you for a name to call, simply press one
of the phone keys, except the pound (#) key. The AP-7000 will switch the line in and let
you dial manually.
H. The AP-7000 is based on a speaker dependent voice recognition engine and technology.
I.
This means that only the person who trained the AP-7000, will be able to use it. However,
two or more users can share the AP-7000, each having is/her own names and numbers
stored and called independently.
J.
The AP-7000 will recognize names best on same the phone which the names where
trained with. Using other phones may work, but can lead to poor recognition results.
Multiple AP-7000 dialers can be placed in one house, each working independently on the
phone which is connected to it.
