ABL Wallbox eMH2, Operating Manual

Page: 24 / 256

| Wallbox eMH2 – Charging procedure
24
NOTE
Operating the Wallbox eMH2 with or without backend
Depending on the model variant, the Wallbox eMH2 can be operated with or without a backend.
ƒ
Master variant: A Master Wallbox eMH2 must always be operated with a backend.
ƒ
Slave variant:
A Slave Wallbox eMH2 may be operated with a Master and its backend, or, by
modifying its configuration, as a stand-alone wallbox without backend.
ƒ
Stand-alone variant: A stand-alone Wallbox eMH2 is always operated without backend.
5
Place the RFID card included in front of the
RFID icon on the housing cover.
6
Check the LED indicators and acoustic signals
of the wallbox.
y
During verification of RFID card
authorisation:
»
The green LED is ON.
»
The blue LED pulsates.
»
The wallbox emits a short acoustic signal.
y
When the RFID card is accepted:
»
The green LED turns OFF.
»
The blue LED pulsates.
»
The short acoustic signal is emitted
twice.
NOTE
Authorisation of the RFID card is refused
If the RFID card is rejected, the red LED flashes and a long acoustic signal is emitted.
ƒ
Operating the wallbox with a backend:
Please contact the issuer of the RFID card.
ƒ
Operating the wallbox without backend: Make sure that the RFID card has been registered at
the RFID reader. You can find further information in the comprehensive installation manual.
7 Check the LED indicators of the wallbox:
y
When the wallbox initiates the charging
procedure following a request by the
vehicle, the blue LED is ON.
y
When the charging procedure is paused or
completed, the blue LED pulsates.