intrOductiOn
5
Identifying your product variant
The eMH1 series comprises several model variants, which are mechanically and/or
electrically adapted to different usage profiles. For identification, a product compliance
plate is located at the back of the lockable housing cover shield near the hinge. Please
open the cover shield before taking the device into operation and check the compli-
ance plate to ensure that the model variant you have installed is the one described in
this manual.
For identification, the model code (EVSE 8XX)
as well as the power supply ratings (voltage,
frequency, current) indicated below it are espe-
cially relevant.
The following wallboxes are described in this manual:
MODEL
GRID CONNECTION
MODEL VARIANT
EVSE 803
230/400 V 50 Hz 16 A
Fixed charging cable with type 2 connector, in-
ternal residual current circuit breaker and DC
fault current detector, three phase, charging
output 11 kW
EVSE 813
230 V 50 Hz 32 A
Identical to the EVSE 803 model variant but
with a charging output of 7.2 kW
CAUTION!
The information and technical specifications contained in this manual re-
late exclusively to the model variants mentioned in these instructions and
must under no circumstances be transferred to other eMH1 models.
Package contents and unpacking
Your eMH1 Wallbox is delivered with a range of accessory components, which are
necessary for the proper operation of the device. Therefore, please check immediately
after unpacking whether the following components are included:
COMPONENT
QUANTITY DESCRIPTION
eMH1 Wallbox
1
Wallbox comprising upper housing part with cover
shield and rear part of the housing, pre-installed on
a wall bracket
Quick start guide
1
Quick start guide including safety notices in printed
form
Key
2
Key for locking the housing cover shield
E8130001
15-11-23
EVSE813
230V 50Hz 32A
IP54
IEC 61851-1
IEC 61439-7 ACSEV
MADE IN GERMANY
ABL SURSUM Bayrische Elektrozubehör GmbH & Co. KG
