Taking into operation and charging procedure
17
DANGER!
If the cable, the charging connector and/or the housing have suffered
mechanical damage or show visible deformities, you must under no cir-
cumstances continue to operate the charging station.
Please contact your local distributor from whom you have purchased the
charging station.
Charging procedure
The
EVSE 563
is engineered for the fastest possible charging of your vehicle according
to IEC 61851-1, Mode 3. The actual charging time depends on the battery fitted to your
vehicle as well as on the energy currently remaining in the vehicle. For these reasons
it is not possible to make a reliable prediction of the charging time: You will discover its
actual value in practice and derive your personal charging routine accordingly.
Please follow the following steps to charge your vehicle:
1. Park your vehicle so that the charging socket can be easily reached with the charg-
ing connector: The charging cable must not be under any strain during the charging
procedure!
2. Open the charging socket on the vehicle.
3. Check the two indicator LEDs on the top part of the
EVSE 563
: When the charging
station is ready for operation, the green LED indicator will flash briefly every 5 sec-
onds, while the blue LED will be not be illuminated.
4. Remove the charging connector from its compartment
by lifting it slightly by the handle
and pulling it down-
ward
.
5. Plug the charging connector into the socket completely:
The charging process will only start when the two signal-
ing pins in the charging connector will each have sent
feedback regarding a safe connection.
Removing the
EVSE 563
charging connector
(illustration is approximate)
