Chapter 3
KX7-333/KX7-333R
3-16
"
Input Delay Value:
This item allows you to adjust the data input strobe delay time of memory. You can key in the HEX
number into this section. The minimum number is 0000, and maximum number is 003F.
DDR DQS Output Delay:
Two options are available: Auto or Manual. The default setting is
Auto
. If you set to
Manual
, then the
next item will be available.
"
Output Delay Value:
This item allows you to adjust the data output strobe delay time of memory. You can key in the HEX
number into this section. The minimum number is 0000, and maximum number is 00FF.
MD Drive Strength:
Four options are available: Auto
(
Low
(
Medium
(
High. The default setting is
Auto
. This item can
adjust the drive strength for data sent to DDR SDRAM. This will depend on your DDR SDRAM
specification and numbers to set. With more DDR SDRAM DIMM installed, you may set it to
High
.
DIMM1&2 CMD Drive Strength:
Four options are available: Auto
(
Low
(
Medium
(
High. The default setting is
Auto
. This item can
adjust the drive strength for commands sent to DDR SDRAM (this adjustment is for DIMM 1 and DIMM
2 only). This will depend on your DDR SDRAM specification and numbers to set. With more DDR
SDRAM DIMM installed, you may set it to
High
.
DIMM3&4 CMD Drive Strength:
Four options are available: Auto
(
Low
(
Medium
(
High. The default setting is
Auto
. This item can
adjust the drive strength for commands sent to DDR SDRAM (this adjustment is for DIMM 3 and DIMM
4 only). This will depend on your DDR SDRAM specification and numbers to set. With more DDR
SDRAM DIMM installed, you may set it to
High
.
Enhance DRAM Performance:
Two options are available: Disabled or Enabled. The default setting is
Disabled
. This item can improve
your system DRAM performance.
DRAM Access:
Two options are available: 2T
(
3T. The default setting is
3T
. This item allows you to choose the
DRAM access time cycle. 2T gives you quicker DRAM access time than 3T; 3T is a general DRAM
setting.
DRAM Queue Depth:
Three options are available: 2 Level
(
3 Level
(
4 level. The default setting is
4 Level
. This item sets
DRAM queue depth to accommodate maximum memory throughput.
Summary of Contents for KX7-333
