Hardware Setup
2-11
(8).
SMB1: System Management Bus Headers
This header is reserved for system management bus (SM bus). The SM bus is a specific implementation
of an I
2
C bus. I
2
C is a multi-master bus, which means that multiple chips can be connected to the same
bus and each one can act as a master by initiating a data transfer. If more than one master simultaneously
tries to control the bus, an arbitration procedure decides which master gets priority.
(9).
JP1: Thermal Sensor Header
This connector is a thermal sensor connector used for detecting the system environmental temperature. It
may also be called a system temperature detector. You can attach one end of a two-threaded thermal cable
to this header, and attach the other end of the thermal cable onto any heat source, such as VGA chipset’s
heatsink, or Hard Disk Drive.
User’s Manual
Summary of Contents for BE7
