ASSEMBLY INSTRUCTIONS
24
LOAD ADJUSTMENT
The resistance of the shock can be adjusted by twisting
the adjustment knob at the top of the shock. There are
settings from 1 to 12. Setting 1 will provide the lowest
resistance. Setting 12 will provide the highest resistance.
Caution:
The shock get
HOT
after a few minutes of use.
ROPE ADJUSTMENT
Over time your
ROPE(51)
may stretch. If the
ROPE(51)
doesn’t retract fully into the
UPRIGHT(3)
and the
HANDLEBAR(9)
doesn’t stay on the
HANDLEBAR HOLDER(50),
make this adjustment. Remove the
HANDLEBAR COVER(52)
by unscrewing the
SCREWS(M4x15mm)(49).
Loosen the
BOLTS(M6x1x20mm) (64),
but do not remove them. Pull
the
ROPE(51)
until there is a 3/8 inch of gap on the shaft of the
SHOCK(42),
refer to illustration A.
Then entwine the
ROPE(51)
around the
BOLTS(M6x1x20mm)(64)
using a figure eight pattern
and tighten the bolts so the
ARC WASHERS(M6)(65)
press against and secure the
ROPE(51)
in position. Re-attach the
HANDLEBAR COVER(52)
with the
SCREWS(M4x15mm)(49).
Adjustment
Knob
Mark
Gap
A
.