21
20
If
Try this
Transmitter status
indicator light
flashing red
• The
transmitter battery level is low. Replace the
batteries if the transmitter is battery powered.
Charge the batteries if it is mains powered.
Important!
If the transmitter is battery powered,
use alkaline AAA batteries only. If the
transmitter is mains powered, use rechargeable
NiMH AAA batteries only. NEVER mix NiMH
batteries with alkaline as the unit can overheat.
Transmitter status
indicator light
flashing purple
• Batteries in transmitter are wrong type or
fitted incorrectly. See above for correct
configuration and fitting of batteries.
Transmitter status
indicator light
flashing white
•
The GSM module is indicating an error. Open
the cover and check the GSM LED above the
-symbol (see
Transmitter overview
on p 6).
•
If the LED is blinking every second, no GSM
network has been detected. Check that the SIM
card is fitted correctly and that you have GSM
coverage in your area, see
Installing a SIM card
on p 7.
When the transmitter is connected to a GSM
network the GSM LED will blink every 3 s.
•
If the problem persists, contact your GSM
provider.
•
If the LED is off, the unit has no GSM module
or the module is out of order. Contact your
dealer for service.
Transmitter status
indicator light
flashing blue
• The
transmitter is ready to be connected to a
wireless alarm unit.
• The alarm unit is faulty, see separate user
manual. If the problem persists, contact your
dealer for service.
Chapter 4
Troubleshooting and other information.
Troubleshooting
Most problems with the system can be quickly solved by following the
instructions below. There are more tips and information on troubleshooting
on our website.
Transmitter
Chapter 4
Troubleshooting and other information.
If
Try this
Pager cannot be charged
• Check that the pager is correctly
placed in the charger. The LED by the
-symbol will blink/light up to show that
it’s charging.
• Check that the charger is connected to
mains power. The LED by the -symbol
is lit to show that it is connected. If the
LED blinks, it is using the backup battery.
Reserve battery in charger
not working and charger
symbol off
• Check batteries are correctly fitted and
charged. Charge or replace batteries,
see
Changing batteries
on p. 18.
Pager charger
If
Try this
Pager symbol is
lit whilst the pager is
vibrating and beeping
• Pager has lost radio contact with a trans
-
mitter. The LED position on the pager will
indicate which transmitter is at fault if you
have several transmitters. Move to within
range of the transmitter.
Pager symbol is lit
whilst the pager is
vibrating and beeping
• A transmitter in the system is indicating
an error. The LED position on the pager
will indicate which transmitter is at fault
if you have several transmitters. See
Troubleshooting transmitter
on p. 20.
Pager symbol is white,
whilst the pager is
vibrating and beeping
• Pager has less than two hours of battery life
left. Charge batteries by putting the pager
in its charger. A full charge takes 6 hours.
Pager symbol is red,
whilst the pager is
vibrating and beeping
• Battery in pager is wrong type, incorrectly
fitted or flat. Check how the battery is fitted
or replace, see
Changing batteries
on p. 18.
Pager not emitting any
sound whilst the
symbol is lit
• Pager sound switched off. Slide sound
switch upwards to restore sound. Switch is
on right side of pager (see overview).
Pager
EN