Alignment jig
6 Operation
BAL.0022 • 2019-04-23
EN - 13
6.2 Adjusting the Bending Angle
1
Plug on/screw in the adjusting sleeve
onto the gas nozzle receptacle.
2
Put the adjusting lever
onto the adjusting sleeve
and correct the bending angle slightly.
Check the concentricity of test mandrel
constantly during this procedure.
The bending angle is correct if the test mandrel
fits easily into the bore of the measuring sleeve
.
CAUTION
Material damage
The torch neck can be damaged in case of too frequent and excessive bending.
• Perform only minor corrections.
1
Test mandrel
2
Measuring sleeve
3
Adjusting sleeve
4
Adjusting lever
Abb. 10
Adjusting
1
2
3
4
