EN - 12
BAL.0046 • 2019-02-07
7 Operation
MIG/MAG ROBO welding torch
7 Operation
7.1 Welding process
1
Open the shielding gas cylinder.
2
Switch on the power source.
DANGER
Shortness of breath and poisoning caused by inhaling phosgene gas
When welding workpieces that have been degreased with chlorinated solvents, phosgene
gas is formed.
• Do not inhale smoke and vapors.
• Ensure a sufficient supply of fresh air.
• Rinse the workpieces with clean water prior to welding.
• Do not place degreasing baths containing chlorine in the vicinity of the welding area.
DANGER
Risk of burns
During welding sparks, glowing workpieces or hot slag can produce flames.
• Check the work area for flashpoints.
• Provide suitable fire extinguishing equipment at the workstation.
• Allow workpieces to cool down after welding.
• Prior to performing welding work, properly fasten the ground clamp to the workpiece or
the welding table.
WARNING
Arc eye
The arc produced by welding can damage the eyes.
• Check and wear your personal protective equipment.
NOTICE
• Never pull the cable assembly across sharp edges or place it in the welding spatter area
or on hot workpieces.
• Ensure that all required parameters, for example welding current, wire feed, etc., have
been set at the welding power source according to your welding task.
