7
FreedomDrive
Putting into operation 4
1
MIG gun Neck
2
Neck Liner
Fig. 3
MIG gun neck liner (optional)
2
x
1
4.3
Installing the optional neck liner in the air-cooled
MIG gun neck
The neck liners must be cut to length, according to the neck. Please be sure to
order the correct neck liner in order to avoid feeding issues
1
Unscrew the gun neck
(1)
from the gun handle.
2
Insert the gun neck liner
(2)
into the gun neck until the end
stops at the contact tip.
3
Measure the length of the neck liner protruding from the neck
inlet (“x”). Subtract 1mm (1 coil) from the measurement (“x”), then
remove the neck liner and trim off the calculated amount from the
front end.
4
Deburr the trimmed end of the neck liner
5
Insert the neck liner into the neck.
Note: When cut correctly, the neck liner should be flush with the
tail inlet of the neck when pressed inward
6
Screw the gun neck
(1)
into the neck seat of the gun handle.
Summary of Contents for FreedomDrive Abimig AT355
Page 23: ...23 FreedomDrive Notes...
