Abicor Binzel ADF 600S, Operating Instructions Manual

Page: 33 / 132

ADF 600S 7 Operation
EN - 15
7 Operation
8 Putting out of operation
WARNING
Arc eye
Welding with a faulty ADF 600S can damage the eyes.
• Immediately stop welding work with the ADF 600S and resolve the malfunctions that occurred.

Tab. 11 Troubleshooting on page EN-18
• Only use an intact ADF 600S .
• Adjust the ADF 600S to your head size.

6 Putting into operation on page EN-9
WARNING
Risk of injury
Injuries may be caused by impact from particles travelling at high speed.
• Wear standard safety goggles under the
ADF 600S .
• Only use the ADF 600S as protection against high-speed particles at room temperature.
NOTICE
• Ensure the proper seating of the ADF 600S .
• Test the seating of the ADF 600S regularly by lifting and reseating the ADF 600S . If the head band
slips in the process, adjust the settings for head circumference and head height.

6 Putting into operation on page EN-9
• For the welding process, please consider all components that are included in the welding system.
• The
ADF 600S may only be operated by qualified personnel (in Germany, see TRBS 1203).
NOTICE
• When putting the system out of operation, ensure that the procedures for switching off each of the
welding system components are observed.
• When the welding process is interrupted or completed, wait until the automatic filter switches from
dark to light depending on the pre-set delay time. Only then, remove the ADF 600S .