Abicor Binzel Abitig WH Series, Operating Instructions Manual

Page: 28 / 76

EN - 10
6 Putting into operation ABITIG
®
WH
Equip the torch neck according to one of the following figures:
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder from the front.
3 Hold the tungsten electrode (3) and the electrode holder and
screw on torch cap (4) .
4 Screw gas nozzle (2) onto torch body (1) .
6.1.1 Equipping TIG welding torches 200WS and 400WS
1 Insert the electrode holder (5) into the torch body (1) from the front.
2 Insert the tungsten electrode (3) into the electrode holder from the front.
3 Hold the tungsten electrode (3) and the electrode holder and tighten the
clamping element using a torque wrench.

Tab. 10 Tightening torques on page EN-10.
4 Screw on torch cap (4) .
5 Screw gas nozzle (2) onto torch body (1) .
6.2 Tungsten electrode
The electrode type is set by EN ISO 6848. The max. length of electrode
depends on the type of torch.

2.3 Technical Data on page EN-4
1 Torch body
2 Gas nozzle
3 Tungsten electrode
4 Torch cap
5 Electrode holder
Fig. 2 Equipping the torch
1
5 3 4 2
Step 1 Step 2-3
Step 4
ABITIG
®
WH 220WS max. 1 Nm
ABITIG
®
WH 400WS max. 1.5 Nm
Tab. 10 Tightening torques