DO NOT use cream
cleaners or bleach.
These substances are
abrasive.
Regularly clean with
mild liquid detergent
or soap and water.
DO NOT use cleaning
pads with abrasive
sur faces as this may
scratch the material.
INSTALLATION GUIDE
Note: This product must be installed by a licensed tradesperson.
This is a general installation guide - there are many factors
that are involved that can alter the installation method.
This product install must comply with the standards in your
respective countr y and must be adhered to by your licensed tradesperson.
Step 1:
Find a structural member within the wall being mounted to (timber stud, concrete wall, timber block)
Step 2:
Install the female brackets onto the wall spread evenly to balance the mirrors weight, screws should
be a minimum of 10 gauge to ensure shear strength, ensure that the screw is installed tightly and has
penetrated a structural material.
Step 3:
Check that the brackets are installed level with eachother
Step 4:
Install the male brackets onto the mirror and ensure that the location of the female and male
brackets align perfectly. Ensure you do not use screws too long when fixing the male brackets as this could
penetrate the mirror. We recommend using 12mm timber screws
Step 5:
Engage a qualified electrician to wire into the driver which is located and pre-fitted into the back of
the mirror
Step 6:
Once wired, it can be mounted by lifting the mirror whilst aligning the male and female brackets, this
does not require glue if brackets are installed correctly.
INSTALLATION MANUAL
BEFORE YOU START
- Contact a qualified tradesmen for installation of this mirror
- Contact a qualified electrician for the wiring installation of this mirror
FEMALE BRACKETS
MALE BRACKETS
