Please read fully and understand Setup Guide prior to operating the TR3!
ABI
(Absolute Innovations, Inc.)
-‐ 855-‐211-‐0598 -‐
www.abiattachments.com
Page
9
of
17
*Note for Step 5 – Due to 3 point hook ups on some models of tractors, it may be necessary to move the tires on the
TR3 forward or back a hole to properly adjust the TR3. If you are not able to adjust the TR3 so that the Leveling Blade and Finish
Rake touch at the same time try moving the wheel forward one hole and then repeat Step 5. For further assistance on setup of
the TR3 contact our Customer Service Department at 855-‐211-‐0598.
SETTING SCARIFIERS FOR USE:
Before setting the Scarifier’s for use in an Arena, check the level of footing throughout the Arena. If the
footing height varies throughout the Arena, it may need to be leveled, using the TR3; before using the Scarifier’s.
For assistance with leveling the Arena, read section “Leveling an Arena” below.
To move the Scarifiers up and down, raise the
TR3 off the Ground. Then remove the ¼” Lynch pin from
the ½” Bent pin, remove the ½” Bent pin. Next, move the
Scarifier up or down until the holes realign at the depth
desired, and reinsert the ½” Bent pin. Secure the ½” Bent
pin by putting back in the ¼” Lynch pin.
When the Scarifiers are pinned in the 2
nd
hole
from the top on the Scarifier tube, the Scarifier’s will be
set to rip at about 2 ½”-‐3”. Adjust the Scarifiers up or
down for more or less depth, as needed for use.
IF THE LEVELING BLADE IS CARRYING TOO MUCH MATERIAL:
1.
Adjust Top Link out to lift the Leveling Blade up more. This will put more downward pressure on the Finish
Rake if this adjustment is made. If the problem continues please contact the ABI Customer Service
Department for additional setup advice.
TO CARRY MORE MATERIAL:
1.
Draw in the Top Link on the TR3. This puts more weight on the Leveling Blade allowing the Leveling Blade
to move more material. Doing this will lift the Finish rake up so it will not be touching ground while
grooming.
