Please read fully and understand Setup Guide prior to operating the TR3!
ABI
(Absolute Innovations, Inc.)
-‐ 855-‐211-‐0598 -‐
www.abiattachments.com
Page
8
of
17
Step 3
– Remove the ½” bent pins from the upright
mast on the back that is locking down the leveling
blade. If these pins are already up then skip this
step and move on to step 4. If the pins are in place
and cannot be removed from the uprights, then
the TR3 may need to be lowered to the ground to
take the pressure off the pins. Remove the pins
and pin each one in the top hole on the uprights.
Step 4
– Make sure the Stabilizing wheels are
mounted in the middle hole on the tire mounted
bracket. This can be adjusted later if needed. For
now make sure the tire is mounted in the center
hole.
Step 5
– With the TR3 and Tractor on a hard flat
surface, and the Scarifiers lifted out of play,
adjust the TR3 using the Top Link (shown on page
5 Step 1 Fig 1 above) so that the Leveling Blade
and the Finish Rake touch at the same time. Once
the Leveling Blade and Finish Rake touch at the
same time; lift the TR3 and set it back down. This
will ensure that everything is properly adjusted. If
Leveling Blade and Finish Rake are not touching
at the same time continue to adjust the TR3 using
the Top Link until they touch after the TR3 has
been lifted and lowered. The TR3 may need to be
adjusted multiple times for it to be level. Make
sure to raise and lower the TR3 after every
adjustment.
