abem WalkTEM 2, Abridged User Manual

Page: 12 / 20

P a g e | 12
ABEM WALKTEM 2 ABRIGDED USER MANUAL
8. USER INTERFACE AND MEASUREMENT CONFIGURATION
KEYPAD FUNCTIONS
Tab for setting up
measurement
parameters. Tab for initiating
and monitoring
data collection.
Tab for file
management and
inversion. Tab for instrument
settings and error
logging. Select existing project to
add in additional stations
or create a new one. Choose your preferred
measurement script with this
drop-down and how many
repetitions on the right; total
time is shown on the right and
details of the script are
summarised below.
Notifies of issues recorded on
the Administration tab.
Select the loop you will use for
measurement. The choice is
limited on an RX Standard.
Shows number of satellites in
use for positioning.
Select one of the internal
damping resistors from the
drop-down or choose to use a
custom external resistor.
Selecting “ Analyze ” provides
instructions on performing a
Rogowski Coil test to assess
which damping resistor to use.
This feature is included on the
RX Advanced and an optional
extra on the RX Standard.
“ Plot ” will show the results of
the Rogowski Coil tests so you
can choose the most suitable
damping resistor.
Select which coils and input you
will use; RC-5 on A is only
option on an RX Standard.
“Ext Power” shows if the office power supply is
attached or the voltage of externally connected 12V
batteries (when connected)
– any external battery will
take over from the “Bat 1” internal battery.
“ TX-8 / TX-20 / TX- 60” indicates
voltage on the TX unit (when
attached).
“Bat 1 / Bat 2” shows the voltage of the internal battery
pair. These run the computer, screen and receiver if there is
no external power source. To do a ‘hot swap’, keep one
battery in place whilst changing the other.
Set-up a schedule for repeated
measurements.
Yellow shows TX is initialising,
green means everything is okay
with the TX / RX and ready to
measure. During measurement,
icons change to show system is
active.