21
Abbey Tub Feeders
5.0 CARE AND MAINTENCE (Contd).
Procedure on changing wheel:
1.
Call a tyre company to fix/replace the wheel. (These companies are professionals with proper lifting
equipment and can have the wheel replaced or fixed on site)
If this is not possible:
2.
Pull up to a level area and apply the handbrake (if fitted) on the trailed machine away from any major
road and Insert wheel jocks on both sides of the inflated wheel.
3.
Remove all contents in the trailed machine.
4.
Loosening the wheel nuts before jacking the machine up.
5.
Use proper lifting equipment.
6.
Place jack under chassis close to the side of the axle you wish to raise.
7.
When raising the machine always use an axle stand as an safety device. Put under axle before lifting
takes place and raise stand every few inches or whenever possible. Do not attempt to lift the machine
unless you have a secondary device to support its weight other than the lifting jack.
Note: Before removing the wheel (if the wheel is over 25kg’s) it is recommended that you have another
.
capable body to give you a helping hand and not to attempt to remove on your own.
8.
Remove and replace wheel. When tightening wheel nuts use the proper torque settings and every
second nut always move to the opposite side of the wheel.
9.
Double check each nut when finished.
Suggested torque settings are shown below:
Torque (d
u
Nm=Kpm)
M14 x 1.4
13
M16 x 1.5
20
M18 x 1.5
27
M20 x 1.5
35
M22 x 1.5
45
M22 x 2
43
M24 x 1.5
55
Summary of Contents for VF1500T
