Installation continued....
FITTING DISPLAYS
Above the controller is a panel window that can be fitted depicting the
product being vended.
Undo the four screws inside the cabinet front door, corresponding to the four
outside corners of the fascia moulding. This leaves the fascia and control
electronics held in place by the centrally positioned M4 nuts.
Held in this way it is possible to
gently
bend the top section of the fascia
forward,
just
enough to slide the panel into place. It is recommended that the
backing card or label is held at the edges with sticky tape. This ensures that
it will not move once installed. Then replace the four corner screws.
FITTING OPTIONAL DISPLAY
This advertising frame bolts to the cabinet back plate and the cover fits over
the point of attachment.
FITTING OPTIONAL PEDESTAL
1. Bolt the ground plate to the floor securely.
2. Fit over the Pedestal casting and column.
3. Securely bolt down the ground plate tie bolt.
4. Using a template, drill the base of the cabinet to accommodate mounting
bolts for the plinth.
5. Use the bolts supplied to secure the cabinet as if bench mounting.
Note
:
It is possible to run the mains cables down the pedestal and exit at
floor level, through a cut out in the rear of the pedestal. In this
application it is necessary to earth the cabinet and the pedestal stand
by cutting and terminating mains cable inside the cabinet.
ABBERFIELD PACKET DISPENSING MACHINE -
model NPD600
OPERATIONS MANUAL # 059-1 page 8
32 Cross St, Brookvale, Sydney NSW 2100, Australia Tel: (02) 99392844 Fax: (02) 99383462 Email: [email protected]
